Remote Access Wizard: Configure Radio - Leica GR10 Operational Manual

Remote access wizard: Configure Radio

Background Information
Radios can be used to connect the receiver to Leica GNSS Spider or other OWI based software, if the radios are configured for
two-way communication.
The radio on the Leica GNSS Spider side must be pre-configured in a way that it can be addressed as serial device.
Go to Receiver Setup / Device Management page to change the communication settings of a device if needed.
Setting Descriptions
The table below describes the settings that can be configured on the Configure Radio page.
Setting
Device
Channel
Connected to
Press to go back to the previous wizard step. Press
Press to cancel and return to Spider and remote access: Overview .
Description
Select the radio device.
The radio channel can only be changed if the radio is attached. If the configured radio device
is not attached, the device will be stored with the default channel 1 (or the last stored channel
when the device was attached) and a message is displayed in the event log.
Only available on the GR25.
Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR/GM10, Serial port 1 is configured automatically as there is
only one serial port available.
For slot in devices, this field is not available, the slot-in port is selected
automatically.
to continue to the next wizard step.
6: Context sensitive help
243