Outgoing Data Stream Wizard: Connection - Leica GR10 Operational Manual

Outgoing data stream wizard: Connection

Background Information
Data can be streamed from the receiver using a variety of communication types.
Setting Descriptions
The table below describes the settings that can be configured on the Connection page.
Setting Description
Connection type Select the connection type.
TCP/IP server
TCP/IP client
NTRIP server (source)
Serial port
Radio
GSM / Modem / CDMA -
dial up
Bluetooth
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.
The receiver works as a TCP server allowing TCP clients
to connect to the receiver's ports to receive the data
streams.
This setting allows the receiver to act as a TCP client and
send data out to a configured IP address and port. This
way no port has to be opened in the firewall to allow
clients to connect to the receiver. Furthermore since the
data stream is now sent to a PC port, the number of
connections to the data stream is not limited by the
receiver.
This mode allows the receiver to act as Ntrip Server, and
to provide data to an Ntrip Caster.
In terms of TCP/IP, the Ntrip server mode is in fact a TCP
client mode. As an Ntrip Server, the receiver connects to
a caster and starts to stream data.
The receiver streams data out of the physical serial port.
The receiver streams data using an attached radio.
The receiver streams data using an attached GSM,
Modem or CDMA dial up service.
The receiver streams data via the Bluetooth serial port.
This data stream can only be connected to if the Bluetooth
device is activated in Receiver setup: Network
connections, Bluetooth tab. tab.
to continue to the next wizard step.
6: Context sensitive help
155