Install Usb Drivers For Windows Xp Operating Systems - Leica GR10 Operational Manual

Install USB drivers for Windows XP operating systems

Follow these steps to install drivers for Windows XP operating systems for the first time:
Step Description
1 Turn on the instrument.
2 Start the computer.
3 Insert the Leica GR/GM Series DVD.
4 Run the installer executable depending on your CPU and operating system to install the drivers necessary for
your GR10/GR25/GM10.
•
32 bit CPU: SetupViva&GR_USB_32bit.exe
•
64 bit CPU: SetupViva&GR_USB_64bit.exe
•
Itanium 64 bit CPU: SetupViva&GR_USB_64bit_itanium.exe
5
The Welcome to the InstallShield Wizard for Leica Viva & GR USB drivers window appears.
Make sure that all GR/GM or Viva devices are disconnected from the PC.
6 Click Next>.
7 The Ready to Install the Program window appears.
8 Click Install. The drivers will be installed on your computer.
9 Click Continue Anyway every time a window pops up saying that the software has not passed the Windows
Logo testing.
10 The InstallShield Wizard Completed window appears.
11 Read the instructions and check the box, I have read the instructions. These instructions are listed in detail
in the following steps.
12 Click Finish to exit the wizard.
13 Click Yes to restart the system so all changes take effect.
For Windows XP users with Service Pack 3: Windows does not require a restart.
14
Loosen the screw on the SD card/USB port cover.
15 Open the SD card/USB port cover.
16 Plug the USB cable into the USB port on the instrument.
17 Plug the USB cable into the USB port of the computer.
18 Wait until the new hardware wizard starts up automatically. Select, No, not this time and click Next>.
It can take some time for the wizard to start.
19 Click Next> to install the software automatically.
20 Click Continue Anyway when a window pops up saying that the software has not passed the Windows Logo
testing
21 Click Finish to exit the wizard.
22 Another Found new hardware wizard starts up automatically. Select, No, not this time and click Next>.
23 Click Next> to install the software automatically.
24 Click Finish to exit the wizard.
Windows will show searching for IP address. Ignore this and go to the next step.
25 Run shortcut Configure GR/GM connection which has been created on the Windows desktop.
There are two more shortcuts created for the GS and CS. These shortcuts can be ignored, unless these
devices will be used on this computer. Refer to the GS or CS User Manual for further information.
5: Getting started
73