Outgoing Data Stream Wizard: Configure Radio - Leica GR10 Operational Manual

Outgoing data stream wizard: Configure Radio

Background Information
This mode allows data to be transmitted with an attached Radio device. The receiver supports eight different types of radios
including seven which attach to the physical serial port via a serial cable and one which attaches to the Slot in port (P3).
Only the radios listed in the Receiver settings: Device Management page are supported.
The port settings for these radios are predefined and cannot be modified.
A radio must be attached before configuration of the data stream in order for the radio channel to be set. If the
radio was detached after or while the data stream had been configured, the receiver must be rebooted for the
radio to work again.
Radio channels can only be set if they are pre-configured on the attached device.
Setting Descriptions
The table below describes the settings that can be configured on the Configure radio page.
Setting
Device
Channel
Connected to
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.
Description
Select the radio device.
Enter the channel that will be used on the device.
Only available on GR25. Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR/GM10, Serial port 1 is configured automatically as there is
only one serial port available.
For slot in devices, this field is not available, the slot-in port is selected
automatically.
to continue to the next wizard step.
6: Context sensitive help
161