Status Tracking: Glonass - Leica GR10 Operational Manual

Status tracking: GLONASS

Field Description
The table below describes the fields in the Status: GLONASS tab.
The information shown is dependent on the settings configured on the GNSS management: Tracking page and which satellite
options are available on the receiver.
Press the Refresh icon to update the displayed data.
Field Description
Sat The Slot number of the satellite.
Elevation The elevation of the satellite in degrees. An arrow is shown to indicate if the satellite is rising or setting.
Azimuth The azimuth of the satellite in degrees.
S/N L1 The signal to noise ratio on L1. The number is shown in brackets if the signal is not currently being used
in the position calculations.
S/N L2P The signal to noise ratio on L2P. The number is shown in brackets if the signal is not currently being
used in the position calculations.
S/N L2C The signal to noise ratio on L2C. The number is shown in brackets if the signal is not currently being
used in the position calculations.
Health Description
Healthy Lists the Slot number of the healthy satellites.
Bad
Lists the Slot number of the unhealthy satellites. The satellites are available in the almanac but are
flagged unhealthy.
Not available Lists the Slot number of the unavailable satellites. The satellites are not available in the almanac.
To enable or disable the automatic update of the status page, please go to Receiver setup: Web server and
activate or deactivate the Automatic status page reload.
If the health status of a satellite is changed by a user and is different to what is sent in the broadcast
ephemeris, this satellite is shown in brackets. Go to GNSS management: Tracking to change the health
status of a satellite.
Related topics
Tracking: General
Tracking: GPS
Tracking: GALILEO
Tracking: SBAS
Tracking: BEIDOU
Tracking: QZSS
GNSS management: Tracking
6: Context sensitive help
107