Leica GR10 Operational Manual page 318

Operational Manual (Online Help)
•
Enable the Source password. An Ntrip server (source) connecting to this data stream to transmit
data will need to provide this password for authentication.
•
Enable Use client authentication if the Ntrip clients are to send user name and password before
being allowed to receive data from a mount point. User name and password are defined per mount
point, not per client. User name and password are therefore the same for all clients connecting to
the same mount point.
7
Press the Save
immediately. Check the event log for a confirmation that the connection was successful.
Ntrip server (source) setup
Step Description
1 Open the receiver's web interface in a browser window by typing in the receivers IP or hostname.
2 Go to the GNSS management / Data streams.
3
Press the Create new data stream
4
Select the Data stream type you wish to stream via the Ntrip protocol. Then press the Continue
5
Configure the data streams details and press the Continue
6
Select the Connection type, Ntrip server (source) in the Connection page and press the Continue
icon.
7 On the Configure NTRIP server (source) page
•
For Ntrip caster IP address enter the IP address of the Ntrip caster the data is to be streamed to.
•
In the TCP/IP port field enter the port at which the Ntrip source can access the mount point on the
Ntrip caster.
•
Enter the Mount point name and password for the mount point to stream data to.
•
If data is to be streamed to an Ntrip caster running on the same receiver as this data stream,
activate the Use local caster check box. This will automatically fill in the IP address and port fields
and hide them. It will also show a list of all mount points configured on the local Ntrip caster. Select
a mount point from the list or enter the mount point name manually. Mount points on the Ntrip caster
can still be created after the data stream has been set up.
Then press the Continue
8
Press the Save
immediately. Check the event log for a confirmation that the connection was successful.
Ntrip client setup
Step Description
1
Open the receiver's web interface in a browser window by typing in the receivers IP or hostname.
2 Go to the GNSS management / Data streams.
3 Open the Incoming data streams tab.
4
Press the Create new data stream
5
Select the Real time in the Data stream type list. Then press the Continue
6 On the Configure real time data stream page
316
button to store the data stream. The receiver will attempt a connection to the Ntrip caster
to open the data streams wizard.
icon.
button to store the data stream. The receiver will attempt a connection to the Ntirp caster
to open the data streams wizard.
icon.
icon.
icon.