Leica GR10 Operational Manual page 299

1 Go to the Receiver Setup / Tools / Firmware page.
2
Click the Upload new firmware file
Click the Browse... button and select the new firmware file.
3
4
Click the Upload
You will be directed back to the Firmware management page once the file upload is complete.
5
Using a FTP client
Step Description
1 Open an FTP client such as Windows Explorer or any other software capable of establishing an FTP
connection.
2 Enter the IP address (hostname) of the GR/GM Series and the username and password of a user with FTP
server read/write access.
3 Copy the firmware file into the Transfer / Firmware folder on the SD Card.
SD Card reader
Step Description
1 Insert the SD card into your PC or a SD Card reader.
2 Copy the firmware file into the Transfer / Firmware directory on the SD Card. This can be done with Windows
explorer or any other PC software.
3 Insert the SD card into the GR/GM Series and turn on the instrument.
4: Install the firmware
After uploading, the firmware must be transferred from the SD card to the System RAM via the Web interface.
Prior to starting the installation, ensure that the GR/GM Series is connected to a reliable power supply.
Step Description
1 Go to the Receiver Setup / Tools / Firmware page.
2 The loadable firmware file will be shown in the table.
3
Click the Install
4 The receiver will automatically reboot following the installation of the new firmware and you will be directed to
the Log in page.
5 To verify if the installation was successful go to the Status / Receiver Information page and view the
installed firmware versions.
Automatic firmware upgrade
The GR receivers allow the firmware upload and installation to be done automatically by the receiver. The receiver will check a
defined location (Leica Geosystems web server or a user defined FTP location) for new firmware versions. If a new firmware
version is available, the receiver will download the file from the defined location to its SD card and install the downloaded
firmware file at a defined time.
Step Description
Please ensure that there are no power interruptions during the firmware upgrade!
1 Maintenance End Check
2 Automatically obtaining the new firmware
3 Automatically installing the firmware
button.
button to copy the file to the SD Card.
button to install the new firmware. This may take several minutes.
7: GR/GM Series Software
297