Configure A Tilt Device Step-By-Step - Leica GR10 Operational Manual

Operational Manual (Online Help)

Configure a tilt device step-by-step

Step Description
1
Use the serial cable which is connected to the tilt device and plug it into the serial port on the instrument.
2 In the web interface go to page GNSS management / Data streams / Incoming data streams.
3 Click on button Create new data stream to open the wizard.
4 Select Tilt as device type and use the Continue button.
5 Select the specific tilt device and the data rate you would like to use and use the Continue button.
6 Tick the Activate data stream check box and use the Save button.
Make sure that the settings of used serial port are identical to the settings of the serial port of the tilt device.
For default tilt devices, this is pre-configured correctly for the standard settings of the tilt device.
344