Leica GR10 Operational Manual page 62

Operational Manual (Online Help)
•
SBAS - Satellite Based Augmentation System
The table below describes the icons used in the Tracking box.
Section Icon Description
No position, indicates that no navigated position is available. This is displayed after a reboot when
the receiver has not started tracking yet. Check that an antenna cable is connected.
Navigated, indicates that a navigated position is available but the configured reference position is
more than 100m away from the navigated position. An error message is displayed in the event log.
Position
User action: Check the configured reference position.
Navigated position available.
Differential code position available.
Phase fixed position available.
Indicates that the satellite system is activated and the receiver is tracking satellites. The number of
currently tracked satellites is shown.
Satellite
Indicates that the satellite system is activated but the receiver is not tracking satellites.
system
Indicates that the satellite system is not activated.
Internal - this receiver is configured to use the internal receive clock (default setting).
TCXO, OCXO, Rubidium, Cesium - The receiver is configured to use the listed external oscillator.
If an external oscillator is configured connected, the receiver will not be able to track any satellites.
An external oscillator is configured with the oscillator fallback option active. No time signal was
Oscillator
detected for more than 5 minutes or the antenna was disconnected for more than 5 minutes. The
receiver is now using the internal clock instead of the selected external oscillator.
60
Number of QZSS satellites available above the cut-off angle. QZSS
Sat. available tracking can only be activated when the QZSS option is installed on the
receiver.
Tracked L1
Tracked QZSS satellites on L1.
Tracked L2C
Tracked QZSS satellites on L2C.
Tracked L5 Tracked QZSS satellites on L5.
Tracked L1 Tracked SBAS satellites on B1.
This is a single fallback after 5 minutes without automatic return to external
oscillator