Remote Access Wizard: Configure Gsm / Modem / Cdma - Leica GR10 Operational Manual

Operational Manual (Online Help)

Remote access wizard: Configure GSM / Modem / CDMA

Background Information
The settings on this page allow Leica GNSS Spider or other OWI based software to use a modem to dial into a modem
connected to the GR/GM Series and configure the receiver.
GSM (Global System for Mobile communications) is a telecommunication standard for transmitting data packages to mobile
phones.
CDMA is a telecommunication standard for transmitting data packages using the Internet protocol.
Setting Descriptions
The table below describes the settings that can be configured on the Configure GSM / Modem / CDMA page.
Setting
Device
PIN code
PUK code
Connected to
Press to go back to the previous wizard step. Press
Press to cancel and return to Spider and remote access: Overview .
244
Description
Select the device to be used. The list shows all GSM / Modem / CDMA devices configured in
the device management.
Enter the PIN (personal identification number) code for the device's SIM card.
The PUK (PIN unblock key) code is a security code for the SIM card used on some devices.
The PUK code needs to be entered when the PIN code has been entered incorrectly more
than three times and the SIM card is blocked. The PUK will unblock the SIM card.
This field can normally remain empty.
Only available on the GR25.
Select the physical serial port for data transmission
•
Serial port 1
•
Serial port 2
For the GR/GM10, Serial port 1 is configured automatically as there is
only one serial port available.
For slot in devices, this field is not available, the slot-in port is selected
automatically.
to continue to the next wizard step.