Configure A Meteo Device Step-By-Step - Leica GR10 Operational Manual

Configure a meteo device step-by-step

Step Description
1
Use the serial cable which is connected to the meteo device and plug it into the serial port on the instrument.
2 In the web interface go to page GNSS management / Data streams / Incoming data streams.
3 Click on button Create new data stream to open the wizard.
4 Select Meteo as device type and use the Continue button.
5 Select the specific meteo device and the data rate you would like to use and use the Continue button.
6 Tick the Activate data stream check box and use the Save button.
Make sure that the settings of the used serial port are identical to the settings of the serial port of the meteo
device.
For default meteo devices, this is pre-configured correctly for the standard settings of the meteo device.
11: External Devices
343