Outgoing Data Stream Wizard: Configure Lb2 Data Stream - Leica GR10 Operational Manual

Operational Manual (Online Help)

Outgoing data stream wizard: Configure LB2 data stream

Background Information
LB2 is the Leica proprietary binary protocol to interface with the receiver. An outgoing LB2 stream can contain measurement
data and/or satellite data.
Setting Descriptions
The table below describes the settings that can be configured on the Configure LB2 data stream page.
Setting Description
Measurement data
Satellite data Activate to stream satellite data and send out ephemeris data (GPS: 0x88, GLONASS: 0xD1)
immediately when new data is available.
Press to go back to the previous wizard step. Press
Press to cancel and return to GNSS management: Outgoing data stream.
152
Step Description
1 Activate to stream LB2 data raw code and phase data for all tracked satellites.
2 Select the message type to be sent out
•
Message D: LB2 (D Message) supports GPS L1 and L2 and
GLONASS L1 and L2 data.
•
Message E: LB2 (E Message) additionally supports GPS L5 and
Galileo signals and is more compact.
3 Select the rate to send the measurement data.
to continue to the next wizard step.