Daihatsu F300 Service Manual page 996

•
•
•
•
15·2. DOOR LOCK CONTROL SWITCH
(Driver side door)
REMOVAL
1. Remove the three screws of the arm rest.
2. Remove the screw of the door inside handle. Remove the
bezel.
3. Remove the door trim board assembly. Disconnect the
wiring coupler.
4. Remove the water seaL
INSPECTION
Ensure that continuity exists between the respective terminals
as indicated in the table below.
1 2
Lock
g
0
Unlock
15-3. DOOR LOCK CONTROL RELAY
INSPECTION
3
0
1. Fabr'1cate a test circuit as indicated ·rn the right frgure.
2. Set the circuit tester to the voltmeter range.
3. When the terminal® is connected to the negative(-) ter-
minal of the battery, ensure that the battery voltage is
momentarily applied across the terminals@ and
®.
4. When the terminal® is connected to the negative(-)
ter-
minal of the battery, ensure that the battery voltage is
momentarily applied across the terminals@ and
@.
How-
ever, the polarity of the voltage at this time should be op-
posite to that under the step® above. page 80
BE-101 •
BODY ELECTRICAL SYSTEM
Door control
switch
12V
Voltage
meter