Daihatsu F300 Service Manual page 1292

•
•
•
•
(3) Install the crankshaft in the cylinder block.
(4) Apply engine oil to the thrust washers. With the side
having the oil groove facing toward the crankshaft side,
insert each thrust washer between the crankshaft main
journal No. 3 and the cylinder block .
(5) Apply engine oil to the crankshaft main journal sections.
NOTE:
• Care must be exercised to ensure that no oil ftows into
the bearing
cap
attaching bolt holes.
(6) instali the crankshaft bearing caps with the arrow marks
facing toward the oil pump side and also in the numeri-
cal sequence.
(7) Thinly apply engine oil to the crankshaft bearing cap
bolts. Tighten the bolts to the specified torque over two
or three stages in the sequence shown in the right
figure.
Tightening Torque: 44.1 - 53.9 N-m (4.5 - 5.5 kgf-m)
2. Assembly of piston and connecting rod
Install the flywheel on the crankshaft temporarily.
NOTE:
• Care must be exercised to ensure that no oil, etc. gets
to the bolts or bolt holes .
EM-151
ENGINE MECHANICALS