Daihatsu F300 Service Manual page 1291

ENGINE MECHANICALS
3. Press the piston pin into the piston and connecting rod,
using a hydraulic press.
4. Remove the piston and connecting rod assembly from the
SST. Remove the SST from the piston pin.
ASSEMBLY OF CYLINDER BLOCK
NOTE:
• As for those parts to be reassembled, wash them in
cleaning solvent (excluding those parts, such as grease-
sealed type bearings, dust seals and
electrical parts).
Then, dry them using compressed air.
• Remove
any
remaining sealer, etc. from the threaded
portions of the switches and sensors.
1. Installation of crankshaft
(1) lnstali the bearings to the cylinder block and crankshaft
bearing caps.
NOTE:
• Do not touch
with
the front and back surfaces of each
bearing.
Be
sure to hold the bearing at
its
edge surfaces.
(2) Lubricate the suriace of each bearing with engine oil.
NOTE:
• Do not touch with the front and back surfaces of each
bearing.
• Never apply engine oil to ihe crankshaft bearing caps.
EM-150
•
•