Daihatsu F300 Service Manual page 1056

HARNESS & WIRING DIAGRAM
Section: Coil, resistor and engine wire Application: R.H.D. vehicles
No.
Operation procedure
1.
Clamp the harness to the dashboard bracket
section, working from the top.
2. Secure the ctamp
to
the dashboard bracket with the
bolt.
3.
Working. from the top, insert the check connector to
the dashboard bracket. until the lOCk is engaged.
4.
When Installing the Clamp to the dashboarCS.SiQe
bracket. enslJ'e that the damp is
not
protruded from
the clamp wictth (.1!). Never bend the clamp
downward.
(Fig. 1)
5.
Place the connector (yellow, waterproof) with
the
dim
dip resistor in front of the harness leading to the coil.
Dim
ip
resistor
Up
L,H
Sec-
lion
A
B
c
D
E
~-"~'
Eng1newrre
[As v~d lrom top]
Rg. 1
Control
Item
Pu""""
Ensure that the clamp is secured
To preyentl'lilrress from
inlerfering
positively.
with brake
and air conditiooer-Rlalr.d
piping and ergine Wire altachiflillnlls
Ensure that the harness is clamped
To prevent the harness from
securely at a point
lower than the
interfering with the brake
tightening point.
tube, etc.
Ensure that the lock is made positively.
To prevent connector from
being disconnected and
interfered
Ensure tl'lat the clamp is installed
To prevent the harness from
within the bracket width.
interfering with the brake
tube
To prevent interference with
distributor and air-bleeding
"""'
Ensure that the connector is positioned To prevent the harness
at front side of the harness leading to connector from interfering
the coil.
with
the resistor
"""""""
Section: Cowl top Application: All carburetor-equipped vehicles
No.
1.
2.
Wiper motor
I
L.H.D.
vehicle!
~
Wiper motor
~
Operation procedure
Secure the harness rising to the cowl top just under the
hinge center by means of a
S-shaped
clamp.
(Clamp the clamp marking tape (yellow) section.)
As for the harness leading
to
the air conditioner VSV,
provide a branch point at inside of the band type clamp.
Sec-
'"'
A
B
Control
item
Ensure that the hamess is secured
positively at the body flange
• ""1...1""\.r
··shaped zone
juSt
below the hinge
center.
Ensure that the branch
starts
from the left
side® of the clamp.
Ensure that the connector and harness are
not sagging, thus interfering the booster
"""' ·
HW-46
To
prevent the harness
to interfere with the
hinge. ®To prevent
"'9
To prevent the harness
looag
To prevent the harness
to interfere
with
the
"""""'"""'
•
•
•
•