ENGINE MECHANICALS
•
[HD-E
engine]
1. Clean the intake manifold.
2. Install the EGR VSV to the surge tank. (US spc only)
NOTE:
.
Apply thin film of the Three Bond 11 04 to the threaded
portion of the bott .
•
3. Install the vacuum hose sub assembly onto the surge tank.
NOTE:
•
Apply
the
thin fllm of the Three Bond 1104
to
the
threaded portion of the bolt.
4. Install the ISC VSV to the surge tank. (US spc only)
NOTE:
•
Apply thin film of the Three Bond 11 04 to the threaded
portion of the bolt.
5.
Clean he threaded portion of the gas filter.
Wind seal tape around the threaded portion and install it to
•
the surge tank.
Tightening Torque:
11.8 - 19.6 N-m (1.2 - 2.0 kgf-m)
NOTE:
•
This operation is required only when the gas filter has
been removed.
•
Use a hexagonal long box wrench for tightening .
0
"""""""'
6.
Install the intake air temperature sensor to the surge tank
with a new washer interposed.
Tightening Torque:
29.4 - 39.2 N-m (3.0 - 4.0 kgf-m)
NOTE:
•
This operation is required only when the intake air
temperature sensor has been removed .
•
""'""'"'
EM-87