Daihatsu F300 Service Manual page 1302

•
•
•
•
21. lnstailation of oil pressure switch
(1) Clean the threaded portion of the oil pressure switch.
W1nd seal tape around the threaded portion.
(2) Tighten the oil pressure switch to the specified torque,
using a long box wrench having a hexagonal hole.
lightening Torque: 11.8-19.6 N-m (1.2- 2.0 kgf-m)
22. Install the alternator.
At this time, temporarily install the alternator
by
installing the
alternator attaching bolts, adjusting bar, adjusting bar at-
taching bolt and alternator adjusting bolt.
ASSEMBLY OF CYLINDER HEAD
1. Align the stamped mark of the crankshaft timing belt pulley
with the indicator
of
the oil pump.
2. Install the cylinder head gasket on the cylinder block .
3. Turn the camshaft, until the "F" mark of the camshaft timing
belt pulley comes exactly
at
the
top
position.
4. Install the cylinder head assembly on the cylinder block.
NOTE:
• Be
very
careful not to damage the cyr.nder head gasket
and cylinder head gasket surface.
EM-161
ENGINE MECHANICALS
0