•
•
•
•
(2) Measure the amount of the drive belt deflection when the
midpoint of the drive belt between the alternator and the
water pump pulley is pushed with a force of 98 N (10 kgf).
Specified Belt Deflection
V belt:
6.0 -
8.0 mm
(0.24-
0.31 inch)
V-ribbed belt:
5.0 - 6.0
mm
(0.20 - 0.24
inch)
NOTE:
"New belt" refers to a belt which has been used on a
running engine for less than five minutes.
•
After installing a new belt, run the engine for about five
minutes and then recheck the tension .
BLOW-BY GAS SYSTEM
Inspection of blow-by gas recirculating system
Check the hose, connections for cracks, leak or damage .
CHARCOAL CANISTER
Inspection of charcoal canister
(1) Disconnect the rubber hoses and remove the charcoal
canister.
HO-E:
(2) Blow air of 294 kPa (3 kgf/cm
2
)
into the pipe @ while hold-
ing the pipe® closed.
Ensure that air flows smooth from the pipe
© .
MA-11
MAINTENANCI
Water pump pulley
WFE90-MAO
WFE90-W