ENGINE MECHANICALS
15. Disconnect the accelerator cable from the carburetor.
16. Remove the hot air shroud from the exhaust manifold by
loosening the five attaching bolts.
17. Disconnect the exhaust pipe from the exhaust manifold by
removing the three attaching nuts.
18. Removal of cylinder head cover
(1) Remove the spark plug wires from the cylinder head.
(2) Remove the spark plugs, using the SST.
SST: os2sa-smo3-ooo
(3) Loosen the cylinder head cover attaching bolts evenly
over two or three stages in the sequence indicated in
the figure. Remove the cylinder head cover attaching
bolts.
19. Removal of cylinder head
( 1) Disconnect the bypass hose from the intake manifold.
(2) Disconnect the water hose from the thermo valve.
(3) Remove the engine electrical wiring harness clamp from
the intake manifold.
(4) Disconnect the water outlet hose at the cylinder head
side.
(5) Disconnect the heater inlet hose at the cylinder head
side.
EM-54
•
•
@
®
@
<D
•
®
(i)
@
@
WFE90-EM151
•
WFE90-EM152