ENGINE MECHANICALS
12. Remove the water inlet and thermostat
by
removing the
trree
attaching bolts.
13. Remove the pressure plate and clutch disc by removing the
six attaching bolts.
NOTE:
Prevent the pressure plate from turning, using the follow-
ing SST.
SST: 09210-87701-000
14. Loosen the attaching bolts of the flywheel in the sequence
as indicated in the right figure. Remove the flywheel.
NOTE:
Prevent the flywheel from turning, using the following
SST.
.
SST: 09210-87701-000
15. Remove the rear end plate by removing the two attaching
bolts.
16. Removal of oil pan
(1) Loosen the ten attaching bolts and four nuts of the oil pan
over two or three stages. Pull out the bolts and nuts.
EM-116
•
•
•
•