Daihatsu F300 Service Manual page 1314

• [HD-E Engine]
•
•
•
(1) Place the air cleaner assembly. Then, tighten the three
air cleaner attaching bolts.
(2) Connect the bolts provided at the left fender panel and
radiator support.
(3) Connect the clamp for clutch cable at the air cleaner.
(4) Connect the intake air hose to the throttle body.
Tighten the clamp for the intake air hose .
{5) Tighten the air chamber bracket tightening bolts and
clamp bolt. Clamp the accelerator cable.
Tightening Torque: 3.0- 4.9 N-m (0.3- 0.5 kgf-m)
(6} Connect the bond cable to the air chamber bracket.
Tighten the attaching bolts .
(Only for the radio-equipped vehicle)
(7) Install the plug wires to the spark plugs.
NOTE:
• Make sure
that
the spark plug wire is connected securely
to each spark plug.
Care should be exercised not to damage the
spark
plug
wire rubber grommet with the spark plug tube.
(8) Connect the t\vo vacuum hoses for air conditioner idle-
up and for power steering.
(9) Install the air intake chamber by tightening the two
clamps and three attaching bolts .
EM-173
ENGINE MECHANICALS