Daihatsu F300 Service Manual page 1208

•
•
•
•
(4) Install the bearing caps and valve rocker shaft. Tighten
them to the specified torque.
Tightening Torque:
M10 bolt 28.4 • 36.3 N·m (2.9 · 3.7 kgf-m)
MS
bolt
12.7 • 16.7
N·m
(1.3 • 1.7
kgf-m)
NOTE:
• Ensure that the bolt holes and bolts are dry when tighten-
ing the bolts.
(5) Remove the bearing caps and measure the oil
clearance.
Clearance:
Specified Value: 0.035 • 0.076 mm
Allowable Umit: 0.17 mm
If the oil clearance exceeds the allowable limtt, replace
the cylinder head and camshaft as a set.
NOTE:
• After completion of the check, remove the plastigages.
Wash the camshaft and bearing caps in cleaning sol-
vent.
9. Inspection of camshaft thrust clearance
( 1) Apply engine oil to the camshaft journals .
(2) Install the camshaft to the cylinder head. Install the
bearing caps and rocker shafts and tighten them to the
specified torque.
Tightening Torque:
NOTE:
M10
bolt
28.4 • 36.3
N-m
(2.9 • 3.7
kgf-m)
MS boh 12.7 • 16.7 N·m (1.3 -1.7 kgf-m)
Ensure that the bolt holes and bolts are
dry
when tighten-
ing the bolts.
(3) With
a
dial gauge attached to the camshaft, measure
the thrust clearance.
Thrust Clearance:
Specified Value: 0.1 • 0.25 mm
Allowable Umit: 0.45 mm
EM-67
ENGINE MECHANICAL$