Daihatsu F300 Service Manual page 1296

•
•
•
•
(3) Apply engine oil to the inner surface of the oil seal.
Install the oil pump to the cylinder block. Tighten the
seven attaching bolts to the specified torque.
Tightening Torque: 5.9 - 8.8 N-m _(0.6 - 0.9 kgf-m)
4. Installation of oil seal retainer
(1) Apply the Three Bond 1207C to the oil seal retainer
installation surface of the cylinder block, as indicated in
the right figure .
(2) Apply
engine oil to the inner surface of the oil seal.
Install the oil seal retainer to the cylinder block. Tighten
the tour attaching bolts to the specified torque.
Tightening Torque: 5.9 - 8.8 N-m (0.6 - 0.9 kgl-m)
5. Install the oil strainer with a new gasket interposed.
Tighten the two o"1l
strainer
nuts and two bolts to the
specified torque.
Tightening Torque: 8.8 - 11.8 N-m (0.9 - 1.2 kgf-m)
6. Installation of oil pan
(1) Apply the Three Bond 1207C to the oil pan installation
surface of the cylinder block, as indicated in the right
figure.
EM-155
ENGINE MECHANICALS
Three Bond 1207C
/
. .
.
:~
. . . .
c....J "'-
Bond application point