Daihatsu F300 Service Manual page 1425

•
•
•
•
Water temperature sensor removal and unit test
1. Disconnect the ground cable terminal from the negative(-)
terminal of the battery.
2. Drain the cooling water.
3. Distributor removal
(1) Turn the crankshaft, until the mark on the crankshaft
timing belt pulley is aligned
with
the indicator mark on
the timing belt cover. Ensure that the rocker arms of the
cylinder No.1 at the timing belt side are in a free state.
If the rocker arms are not in a free state, turn the
crankshaft one more complete turn 360°.
(2) Remove the spark plug wires from the distributor cap.
NOTE:
• Be
sure to remove
the
spark plug wire by holding the
rubber grommet Never pull out the cord section.
(3) Disconnect the distributor connector.
(4) Disconnect the vacuum hoses from the vacuum advan-
cer.
(5) Remove the distributor by removing the distributor set
bolts.
NOTE:
• Since the oil flows out during the removal, place a
suitable cloth underneath the distributor.
4. Removal of water temperature sensor
(1) Remove the water temperature sensor connector.
(2) Remove the water temperature sensor .
EF-57
EFISYSTEM