Daihatsu F300 Service Manual page 1297

ENGINE MECHANICALS
(2) Place the oil pan gasket.
NOTE:
Ensure that the end section of the oil pan gasket is
overlapped at least 10 mm with the Three Bond 1207C.
(3) Install
the
oil pan. Tighten the four oil pan attaching nuts
and ten bolts to the specified torque over
two
or three
stages.
Tightening Torque: 6.9 - 11.8 N·m (0.7- 1.2 kgf-m)
7. Install the rear end plate.
Tighten the two rear end plate attaching bolts to the
specified torque.
Tightening Torque:
9.8- 14.7 N·m (1.0- 1.5
kgf-m)
8. Installation
d
flywheel
(1) Install the flywhee on the crankshaft.
(2) Application of flywheel bolt sealing material
(j)
Wash the flywhee bolts. Then, degrease and dry
them.
NOTE:
• When degreasing the bolts, remove any oil com-
pletely, using a solvent such as a degreasing
spraying agent or alcohol.
CAUTION:
Make sure that no bond nor other foreign matter,
such as dus1, gets to the bolts.
Even when new bolts are used,
be
sure
to
per·
form this operation.
EM--156
•
Three
•