Daihatsu F300 Service Manual page 1254

• 28. Remove the oil level gauge guide attaching bolt.
•
•
•
29. Remove the oil level ga:.Jge guide from the cylinder block.
30. Removal of cylinder head cover
(1) Remove the ground cable from the cylinder head cover.
(2) Remove the spark plugs, using the SST.
SST: 0926B-Bn03-000
(3) Loosen the cynnder head cover attaching bolts evenly
over two or three stages in the sequence indicated in the
figure.
Remove the cylinder head cover attaching bolts.
31. Removal of cylinder head
(1) Loosen the cylinder head bolts, using a hexagon wrench.
CAUTION:
Loosen the cylinder head bolts evenly over two or three
stages in the sequence indicated in the figure.
(2) Remove the cylinder head with the intake and exhaust
manifolds .
NOTE:
• If it
is
difficult to remove the cylinder head, pry up the
cylinder head, using an iron bar.
CAUTION:
• Place the removed cylinder head on suitable two wooden
blocks in order that the cylinder head surface and valve
may not be damaged.
DISASSEMBLY OF CYLINDER BLOCK
1. Remove the oil pressure switch.
NOTE:
•
Use a hexagon box wrench for the removal operation .
EM-113
ENGINE MECHANICAL$
® ®
&.•
(j) @ ®