•
•
•
•
13. Apply silicon oil to the "0" ring of the injector.
Then, install the delivery pipe.
CAUTION:
•
Be very careful not
to
damage the
"0"
ring of the injector
during the delivery pipe installation.
•
Do not install the delivery
pipe
diagonally to the injector.
14. Tighten the attaching nuts of the delivery pipe.
Tightening Torque:
14.7- 21.6 N-m (1.5- 2.2 kgf-m)
NOTE:
•
After tightening the delivery pipe, make sure that the
injector can be turned by hand. If the injector can not
be
tumed,it indicates probably a damaged injection
·o·
ring.
Hence, replace the injector
"CI'
ring
with
a new part.
15. Install the surge tank
stay
No. 1 to the throttle body and
intake manifold, using bolt and nut.
Tightening Torque:
Bolt:
14.7-21.5 N-m (1.5-
22
kgf-m)
Nut:
14.7 - 21.5 N-m (1.5 - 2.2 kgf-m)
16. Install the engine hanger No.2 and surge tank
stay
No.3
to the stud batt at the cylinder head. Install the surge tank
stay No. 3 to the surge tank side.
Tightening Torque:
Bolt:
18.6 - 30.3 N-m (1.9 - 3.1 kgf-m)
Nut:
18.6 - 30.3 N-m (1.9 - 3.1 kgf-m)
EM-89
ENGINE MECHANICAL$
WFE90-EM247
~
~
Correct
c;>
I]@
~
OOc:;;
n~
~
Wrong
t:::;),
"""""""