Daihatsu F300 Service Manual page 1184

•
•
•
•
( 1) Align the "F" mark of the camshaft timing belt pulley with
the indicator on the cylinder head cover.
CAUTION:
• It should be noted that the piston may interfere with the
valves if the camshaft is turned independently.
(2) Align the stamped mark of the crankshaft timing belt
pulley with the indicator.
CAUTION:
• It should be noted that the piston may interfere with the
valves if the crankshaft is turned independently .
(3) Assemble the timing belt in such a way that the two
mating marks on the timing belt may be aligned with the
corresponding stamped marks on the crankshaft timing
belt pulley and camshaft timing belt pulley.
NOTE:
• When the timing belt is reused, install the timing belt in
such a way that there exist 35 teeth of the belt between
the stamped marks of the crankshaft timing belt pulley
and camshaft timing belt pulley.
• When the timing belt is reused, install the timing belt in
such a way that the arrowhead which was put during
disassembly comes rotational direction of the timing belt
(4) Loosen the attaching bolt of the timing belt tensioner.
Apply tension to the timing belt. Temporarily tighten the
attaching bolt.
NOTE:
• Ensure that the belt exhibits no slack at the tension side
of the belt (the side opposite to the tensioner) .
EM-43
ENGINE MECHANICAL