Daihatsu F300 Service Manual page 1235

Hide thumbs Also See for F300:

Table of Contents

ENGINE MECHANJCALS

When installing the grommet, drive

using the following SST.

09388-87702-000

Make sure that the grommets is not tilted when

driven into position.

use a suitable wooden piece so as to prevent

the cylinder head cover from damage.

Be careful not to damage the lip section of the grommet.

(4) Apply the Three Bond 1104 to the cylinder head at

points indicated in the figure.

(5) Install the cylinder head cover to the cylinder head.

Be careful not to scratch the rubber grommet for the

spark plug tube during the installatkln.

Care must be exercised to ensure that the rubber grom-

not ride over the spark plug

(6) Tighten the cylinder head cover bolts evenly over two

or three stages to the specified torque. following the

sequence shown at the figure.

Tightening Torque:

2.9 - 4.9 N-m (0.3 - 0.5 kgf-m)

oxygen sensor harness

(8) Connect the blow-by gas hoses to the cylinder head

and throttle body.

Install the timing belt cover.

Tightening Torque:

2.0 - 3.9 N·m (0.2 - 0.4 kgf-m)

Attaching bolts

and @ should be installed first of all.

,.---------,·

Chapters

Table of Contents