ENGINE MECHANICALS
REMOVAL OF CYLINDER HEAD WITH
MANIFOLDS
[HD-C Engine]
1. Removal of battery
(1) Disconnect the battery ground cable from the negtive
(-) terminal of battery.
Then disconnect the positive cable from the positive ( +)
terminal.
(2) Remove the battery from the engine compartment by
removing the battery holding clamp.
2. Drain the coolant
3. Drain the engine oil
4. Removal of engine hood.
(1) Disconnect the window shield washer hose
(2) Remove the engine hood by removing four bolts.
5. Removal of air cleaner assembly.
(1) Disconnect the flowing hoses at air cleaner side.
•
lTC vacuum hose to carburetor
•
Vacuum hose to TVSV
•
PCV hoses
•
Vacuum hoses for vacuum motor
(2) Remove the air cleaner by removing the attaching bolt
and wing nut.
6. Removal of the power steering pump assembly
(Power steering equipped vehicle only)
(1) Loosen the adjusting bolt and two attaching bolts. Then
pull down the pump.
(2) Remove the drive belt.
(3) Disconnect two tightening bolts.
(4) Remove the power steering pump assembly and put on
the battery carrier temprarily.
(5) Disconnect the vacuum hose for idle up.
EM-50
•
•