Daihatsu F300 Service Manual page 1260

•
•
•
•
NOTE:
• Arrange the disassembled pistons and connecting rod in
order that their installation positions may be known readi-
ly.
Care should be exercised so as not to damage the
bearings.
22. Loosen the attaching bolts of the flywheel in the sequence
as indicated in the right figure. Remove the flywheel.
NOTE:
Prevent the flywheel from turning, using the following
SST.
SST: 09210-87701-000
23. Removal of crankshaft
(1) Gradually loosen the main bearing cap bolts over three
S"".ages in the numerical sequence shown in the figure.
Remove the bearing cap bolts.
(2) With the main bearing cap bolts inserted into the bolt
holes of the main bearing cap, wiggle the bearing cap
back and forth. Remove the bearing cap together
with
the lower bearing.
NOTE:
Keep the lower bearing fitted to the main bearing cap.
• Arrange the removed main bearing caps in order.
(3) Lift off the crankshaft.
NOTE:
•
Be very careful not to allow the main bearings to be mixed
with the bearings of the other cylinders.
Remove the thrust washer .
EM-119
ENGINE MECHANICALS
@\~~~~-
®
~~)®
~~~
-"'
q~l
.
!=e
.
J.
(j).
>--® •
.a
~
®
• I\(])
t'
0 0
0