Daihatsu F300 Service Manual page 1278

•
•
•
•
2. Installation of rear oil seal
Dr'rve a new
rear
oil seal into position, using the following
SST.
SST: 09223-4101Q-OOO
NOTE:
• Care must be exercised to ensure that the oil seal is not
driven in a tilted state.
REPLACEMENT OF FRONT OIL SEAL
1. Removal of front oil seal
Remove the front oil seal from the oil pump, using a pin
punch.
NOTE:
• Be very careful not to damage the oil pump during the
removal.
2. Installation of front oil seal
Drive a new front oil seal into position. using the following
SST.
SST:
0931Q-87102-QOO
REPLACEMENT OF CYLINDER BLOCK
NOTE:
• The cylinder block is furnished along with the pistons as
a set. Hence, make sure that each piston is installed in
the mated cylinder bore.
1. Wash the cylinder block using cleaning solvent.
2. Drive the oil orifice until it is recessed 3.0
±
1.0 mm from
the cylinder upper surface.
NOTE:
• For drfving this oil orifice, use an iron rod having an outer
diameter of 10 mm .
EM-137
ENGINE MECHANICALS