Daihatsu F300 Service Manual page 1236

•
•
•
•
4. Installation of crankshaft pulley
{1) Prevent the crankshaft from turning by placing the gear
shift lever in the 5th gear position, and pull the parking
break lever.
(2) Install the crankshaft pulley on the crankshaft timing belt
pulley with four bolts.
lightening Torque: 19.6-29.4 N-m (2.0- 3.0 kgf-m)
5. Installation
of
fluid coupling with fan and fan shroud
(1) Install the water pump pulley to the water pump with
temporarily attaching.
(2) Insert the radiator fan shroud together with the fluid
c::lupling with fan between radiator and the engine.
NOTE:
Be
sure that the water pump pulley is not ride to the
spigot section of the water pump pulley seat.
(3) Install the fluid coupling with fan to the water pump by
means of four bolts through water pump pulley.
Tightening Torque: 9.8- 17.7 N·m (1.0 -1.8 kgf-m)
(4) lr.sert the lock section of fan shroud to the radiator.
Then, tighten the two attaching bolts of the radiator
upper side.
(5) Connect the water hose to the radiator upper tank.
Securely clamp the water hose clamp.
6. Install the V ribbed belt and perform the adjustment in such
a way that the deflection at the midpOint between the water
pump pulley and the alternator may become the specified
value when a force of 98N (10 kgf) is a applied to the
midpoint.
Used
Belt: 5.0 - 6.0 mm
Wrth a force of 98N (10 kgf) applied to point
indicated in figure
7. Install the reserve tank to the radiator assembly bracket.
Insert the over flow hose to the radiator.
8. Install the spark plug, using the following SST.
SST: 09268-87703-000
EM-95
ENGINE MECHANICALS
~I