Daihatsu F300 Service Manual page 1188

•
•
•
•
(2) Set the drive belt tension to specified valve by tighten-
ing the adjusting bolt.
Specified Deflection: 9 -11 mm
[When a force of 98 N (1 0 kgf) is applied]
(3) Tighten the bolts and nut to the specified valve.
Tightening Torque:
@ .... 34.3 - 44.1 N·m (3.5 - 4.5 kgf-m}
@ .... 14.7- 21.6 N·m (1.5- 2.2 kgf-m}
© ....
49.0 - 68.6 N-m (5.0 - 7.0 kgf-m)
12. Installation of reserve tank.
( 1 ) Install the reserve tank to the radiator assy bracket.
(2) Install the reserve tank hose to the radiator with clip.
13. Installation of the air cleaner and the air cleaner hose .
[HD-C Engine]
(1) Connect the vacuum motor hose to the air cleaner hose.
(Except G.C.C. specification)
(2) Connect the hot air intake hose to the pipe.
(3) Connect the air cleaner hose to the air cleaner case and
the pipe with two bolts and one clamp.
[HD-E Engine]
(1) Put the air cleaner and the air cleaner hose into position.
(2) Tighten the three air cleaner attaching bolts.
(3) Tighten the air cleaner hose attaching bolts provided at
the left fender panel and the radiator center support .
EM-47
ENGINE MECHANICALS
\
Pushing force of/'\
98 N (10 kgf) '