Daihatsu F300 Service Manual page 1396

EFISYSTEM
Output form of diagnosis code
(1) Indication of normal code number
(Code number 1 - normal function)
The check engine lamp glows for 0.5 second, 4.5
seconds later after the ignition key switch has been
turned ON. After a lapse of 4.5 seconds, the check
engine lamp again glows for 0.5 second. Then, this
pattern will be repeated.
(2) Indication of malfunction code number
• When a single malfunction code is indicated:
The check engine lamp repeats glowing the same
times as the number of the malfunction code at
intervals of 0.5 second, 4.5 seconds later after the
ignition key switch is turned ON. After a lapse of 4.5
seconds, the check engine lamp again repeats
glowing the same times as the number of the mal-
function code at intervals of 0.5 second. Then, this
pattern will be repeated.
When plural malfunction code numbers are indi-
cated:
The check eng'1ne lamp repeats glowing the same
times as the number of the first malfunction code at
intervals of 0.5 second, 4.5 seconds later after the
ignition key switch is turned ON. After a lapse of 2.5
seconds, the check engine lamp repeats glowing
the same times as the number of the next malfunc-
tion code at intervals of 0.5 second.
The memorized code numbers are indicated in the
sequence of code number, starting from a smaller
number.
The indication of the malfunction codes is repeated
4.5 seconds later after the memorized code num-
bers have been indicated.
5. After the diagnosis codes have been read, remove the SST
from the check terminal.
6. Install the cap on the check terminal.
Cancelling diagnosis code
To erase the diagnosis codes memorized in the ECU after
malfunctions have been repaired, disconnect the battery
ground cable from the negative (-)terminal of the battery. For
at least
10
seconds with the ignition switch turned OFF. [When
ambient temperature is about 2QOC.]
NOTE:
• When disconnecting the fuse,
be
sure to use a fuse
puller. The fuse puller is located at the upper section of
the block in the vehicle interior.
EF-28
•
0.5 second · 0.5 second
Glowln~
4.5 4.5
seconds seconds
Extinguished
In case of malfunction code number 3
:J~-~~.
~Jlls~to.
0.5 second
Glowing
j_o.5
second
r
2.5seconds
O.Ssecond
4.5 seconds
•
•