Daihatsu F300 Service Manual page 1124

•
•
•
•
Engine oil filter replacement
(1) Remove the oil filter, using the following SST.
SST: 09228-87201-000
NOTE:
Since the oil flows out during the replacement, receive the
oil with an adequate container.
(2) Inspect and clean the oil filter installation surface.
(3) Apply clean engine oil to the gasket of a new oil filter.
(4) Installation of oil filter
Screw in the oil filter lightly by hand until the oil seal surface
contacts the oil cooler.
Then, tighten the oil filter one more turn, using the SST.
SST: 09228-87201-000
FUEL FILTER
Fuel filter replacement
• carburetor installed engine:
Disconnect the hose clamp. Then, replace the fuel filter.
• EFI installed engine:
Loosen the union bolt slowly and pull it out.
WARNING:
The fuel in the fuel pipe is pressurized to a pressure of
2.55 kg/cm
2
(36.27 psi).
Therefore, the union bolt should be removed slowly. Other-
wise, the fuel may
be
splashed.
FUEL LINES & CONNECTION
Inspection of fuel lines and connections
Visually inspect the fuel lines for cracks, leakage, loose con-
nections, or deformation .
MA-9
MAINTENANCE
WFE90-MA01