Daihatsu F300 Service Manual page 1309

ENGINE MECHANICALS
12. Installation of engine wire harness
(1) Installation of engine wire harness for ECU
CD
Install the engine wire connector for ECU to the cowl
side panel at the passenger seat side through the
dash panel.
®
Connect the engine wire connector to the engine
control computer assembly.
@
Install the ECU cover at the cowl panel of passenger
seat side.
(2) Connect the following connectors.
CD
Oxygen sensor
®
®
Water temperature sensor®
@
Water temperature sender gauge @
@ Air conditioner water temperature switch (f)
@ Pressure sensor, pressure VSV and clamp@
@
Air conditioner idle-up VSV@
®
EGR VSV@ (U.S. speclfications only)
®
Idle speed control VSV ®(U.S. specifications only)
®
Intake air temperature sensor®
®
Throttle position sensor
<D
(3) Connect the four injector connectors.
(4) Connect the engine wire clamps and engine ground
cables.
13. Connection of distributor
(1) Install the distributor into the cylinder head.
(2) Tighten the two attaching bolts.
(3) Connect the distributor wire connector.
Tightening Torque: 14.7-21.6 N·m (1.5- 2.2 kgf-m)
EM-t68
•
•