Daihatsu F300 Service Manual page 1187

ENGINE MECHANICALS
9. Installation of fluid coupling with fan and fan shroud
(1) Install the water pump pulley to the water pump with
temporarily attaching.
(2) Insert the radiator fan shroud together with the fluid
coupling with fan between radiator and the engine.
NOTE:
• Be sure that the water pump pulley is not ride to the
spigot section of the water pump pulley seat.
(3) Install the fluid coupling to with fan the water pump by
means of four bolts through water pump pulley.
Tightening Torque: 9.8 - 17.7 N·m (1.0- 1.8 kgf-m)
(4) Insert the lock section of fan shroud to the radiator.
Then, tighten the two attaching bolts of the radiator
upper side.
(5) Connect the water hose to the radiator upper tank.
Securely clamp the water hose clamp.
10. Installation of V belt
( 1 )
Install the
V
belt.
(2) Perform the adjustment in such a way that the deflection
at the midpoint between the water pump pulley and the
alternator may become the specified value when a force
of 98 N (10 kgf) is applied to the midpoint.
Specified Belt Deflection:
New Belt:
4.0 - 5.0
mm
With a force of 98 N (1 0 kgf) applied to
point indicated in figure
Used Belt:
5.0 - 6.0 mm
With a force of 98 N (1 0 kgf) applied to
point indicated in figure
NOTE:
•
The used belt denotes a belt which has been used for
more than five minutes after it was put into use.
11. Installation of power steering drive belt
(Power steering equipped vehicle only)
(1) Install the power steering drive belt.
EM-46
~·
~(
•
Alternator pulley
WFE90-EM119
•
•