Daihatsu F300 Service Manual page 1295

ENGINE MECHANICALS
( 13) Apply engine oil to the bearing surface of each connect-
ing rod bearing.
NOTE:
• Do not touch with the bearing front surface.
(14)Remove the vinyl hoses which were attached to the
connecting rod bolt sections.
( 15) Install the connecting rod cap with the front mark facing
toward the oil pump side.
(16)Prevent the crankshaft from turning, using the following
SST.
SST: 09210·87701·000
( 17) Thinly apply engine oil to the connecting rod cap attach-
ing nuts. Tighten the nuts to the specified torque evenly
over two or three stages.
lightening Torque: 34.3 • 44.1 N-m (3.5 • 4.5 kgf·m)
(18)Perform the operations described in the steps (1)
through (18) for each cylinder.
(19)Remove the flywheel.
(20)Remove the following SST.
SST: 09210-87701·000
3. Installation of oil pump
(1) Apply the Three Bond 1207C to the oil pump installation
surface of the cylinder block, as indicated in the right
figure.
(2) Replace the
Ma~
ring of the oil pump with a new part.
EM-154
•
•
•
Three Bond 1207C
•