Daihatsu F300 Service Manual page 1238

•
•
•
•
12.
lnstallaf1on of
the distributor
(1) Replace the UO" ring of the distributor body with a new
one.
NOTE:
Care must be exercised to avoid scratching the new "0"'
ring.
(2) Align the cutout section of the distributor proper with the
cutout groove of the coupling Assemble the d"1stributor
on the cylinder head, lining up the protrusion of the
distributor with the camshaft groove.
During this installation, the aligned cutout sections must
come at the top side of the engine .
(3) With the center of each elongated hole on the flange
section of the distributor proper aligned with the cor·
responding threaded hole
of
the cyl'lnder head, tighten
the distributor attaching bolts.
Tightening Torque: 14.7-21.6 N-m (1.5- 2.2 kgf-m)
(4) Connect the distributor connector .
13. Connect the spark plug wire.
CAUTION:
Hold the rubber boot section of the spark plug wire.
Securely connect it to the spark plugs, the distributor cap
and the ignition coil.
• Be careful not to damage the spark plug wire with the
spark plug tube.
14. Connect the spark plug wire to the cord clamp .
EM-97
ENGINE MECHANICALS