Daihatsu F300 Service Manual page 1226

•
•
•
•
2. Connect the fuel hose to the fuel pump.
Attach the hose bands.
NOTE:
• The knobbed section of tile hose clip for the fuel hose
between the fuel pump and the carburetor should be
faced down ward.
3. Installation of intake manifold
(1) Attach the intake manifold to the cylinder head.
(2) Install the water by-pass pipe to the stud bolt of the
cylinder head, as shown in the figure.
Connect the by-pass hose to the intake manifold. Attach
the hose bands.
(3) Install the oil pressure switch wire clamp
to
the stud bolt.
as shown in the figure .
(4) Tighten the intake manifold attaching bolts and nuts
evenly to the specified torque over two or three stages
in the sequence as indicated in the figure.
Tightening Torque: 14.7 - 21.6 N·m (1.5 - 2.2 kgf-m)
4. Connect the water hose to the thermo valve. Attach the hose
bands .
5. Connect the brake booster hose to the intake manifold in
such a way that the arrow mark of the booster hose faces
the intake manifold side.
6. Install the water hose c1amp to the intake manifold .
EM-85
ENGINE MECHANICAL$