EMISSION CONTROL SYSTEM
INSPECTION OF EGR VACUUM MODULATOR
1. Remove
the
EGR vacuum modulator.
2. Plug the
port
P with your finger. Blow air into the port
Q.
Ensure that air continuity exists.
If no air continuity exists, replace the modulator.
3. Apply a pressure 49.0 kPa (0.2 kgf/cm
2
)
to the pressure
discharge port of the modulator, using a MityVac.
Under this setting, blow air into the modulator through the
port
Q
with the port P plugged by your
f1nger.
Ensure that
no air continuity exists.
If air continuity exists, replace the modulator.
INSPECTION OF EGR VSV
(See page EF-181.)
EC--24
•
Q
Air
•
WFE90-EC073
•
•