Daihatsu F300 Service Manual page 1300

•
•
•
•
13. Install the alternator bracket.
Tighten the one alternator bracket attaching bolt and nut to
the specified torque.
Tightening Torque: 34.4 - 49.0 N·m (3.5 - 5.0 kgt-m)
14. Assemble the tensioner tension spring as indicated in the
right figure. Push the tensioner to the alternator side as far
as it will go. Tighten the tensioner temporarily .
15. Install the crankshaft puUey flange in such a way that its
recessed side may come at the cylinder block side.
16. Install the crankshaft timing belt pulley.
17. Install the crankshaft timing belt attaching bolt. Tighten the
bolt to the specified torque .
Tightening Torque: 88.3- 98.0 N·m (9.0- 10.0 kgt-m)
NOTE:
• Prevent the crankshaft from turning, using the following
SST.
SST: 09210-8n01-000
18. Install the compressor mounting bracket.
(Air conditioner equiped vehicle only}
Tighten the four compressor mounting bracket attaching
bolts to the specified torque.
Tightening Torque: 29.4-44.1 N·m (3.0- 4.5 kgt-m)
EM-159
ENGINE MECHANICALS