Daihatsu F300 Service Manual page 1290

• REMOVAUINSTALLATION OF RING GEAR
•
•
•
1. Place the ring gear on an adequate wooden block. Drive
out the ring gear, using a chisel in combination with a
hammer.
2. Place a new ring gear horizontally on the flywheel.
3. Using a gas burner, heat the ring gear evenly, until the ring
gear due to its own weight fits onto the flywheel .
NOTE:
• Do not tap the ring gear using a hammer or the
like.
Never cool the ring gear quickly using water or the Hke.
4. Allow the ring gear to cool naturally.
ASSEMBL V OF PISTON AND CONNECTING ROD
1. Install the piston pin to the following SST in a way shown in
the right figure.
SST: 09221-87705-000
2. Install the piston and connecting rod in the SST in a way
shown in the right figure. Insert the SST installed with the
piston pin into the piston pin hole.
SST: 09221-87704-000
09221-87705-000
NOTE:
The piston and connecting rod should be assembled in
such a way that the piston front mark and connecting rod
front mark come in the same direction.
EM-149
ENGINE MECHANICAL$
~
09221-87705-000
~
Front
mark