Daihatsu F300 Service Manual page 1196

• (6) Loosen the cylinder head bolts, using a hexagon
•
•
•
wrench.
NOTE:
• Loosen the cylinder head bolts evenly over two or three
stages in the sequence indicated in the figure.
(7) Remove the cylinder head with intake and exhaust
manifold, by using the chain block.
NOTE:
• Be careful not to allow the cylinder head to M to the
vehicle body and/or other
parts.
• Place the removed cylinder head on suitable two
wooden blocks in order that the cylinder head surface
and valve may not
be
damaged.
(8) Remove the cylinder head gasket.
[HO-E Engine]
1. Removal of the battery
(1) Disconnect the battery ground cable from the negtive
(-)terminal of the battery.
Then disconnect the positive cable from the positive ( +)
terminal.
(2) Remove the battery from the engine compartment by
removing the battery holding clamp.
2. Drain the coolant.
3. Drain the engine oil
4. Removal of engine hood.
(1) Disconnect the window shield washer hose .
(2) Remove the engine hood
by
removing four bolts.
5. Removal of the air intake chamber.
(See page
EM-17.)
EM-55
ENGINE MECHANICALS