Daihatsu F300 Service Manual page 1223

ENGINE MECHANICAL$
(7) Install the valve rocker shaft on the camshaft caps.
NOTE:
• For easier installation,
it
is advisable to insert the rocker
arm first to the camshaft cap side.
(8) Clean the attaching bolts and dry them with com-
pressed air. Install them to the cylinder head through
the rocker shafts and camshaft caps. Tighten the bolts
evenly over two or three stages to the specified torque.
TJQhtening Torque:
M10 bolt 28.4- 36.3 N-m (2.9- 3.7 kgf-m)/ Dry
M8 be~ [1 2.7 - 16.7
N·m
(1 .3 - 1.7
kgf-m)/ Dry]
CAUTION:
• Never exceed the specified tightening torque.
• The bolts and bolt holes should
be
dry when tightening
the bolts.
• When using compressed air, protect your eyes with
safety goggles.
7. Install the spacers into between the intake valve rocker
arms on the rocker shaft.
8. Clean the threaded portion of the water temperature sensor.
Wind seal tape around the threaded portion and install the
sensor to the cylinder head.
nghtening Torque:
24.5 - 34.3
N-m
(2.5 - 3.5
kgf-m)
NOTE:
• When using a new water temperature sensor, seal tape
is unnecessary since seal material is coated on the
water temperature sensor.
• Ensure that the water temperature sensor is installed
horizontally.
9. Clean the threaded portion of the water temperature sender
gauge. Wind seal-tape around the threaded portion.
Tighten the gauge to the cylinder head, using the long box
wrench.
nghtening Torque:
11.8-19.6
N-m
(1.2- 2.0
kgf-m)
NOTE:
• When using a new sender gauge, seal-tape is unneces-
sary since seal material is coated on the sender gauge.
EM-82
•
•
•
•