Daihatsu F300 Service Manual page 1013

Hide thumbs Also See for F300:

Table of Contents

HARNESS & WIRING DIAGRAM

Wiring Color Code

For identification purpose, each wire has its own color.

Each color bears a code as described in the right table.

These codes are used in the wiring diagram and will be

helpful during trouble shooting.

The wire color comes in two kinds: single color and com-

posite color. In the case of single color, the whole outer coat

of the harness is of a single color.

In the case of composite color, a fine line of the second

color is drawn on the harness basic color.

In this case, the code is composed of the basic color code

which comes first and the second color code which comes

after a hyphen.

Installing position

The fuse block is located at the left side of the steering wheel.

REPLACEMENT OF FUSES & FUSIBLE LINK

The fuse replacement must be made at all times by using a

new fuse w'1th the correct amperage.

(1) Before any fuse is replaced,

certain to tum OFF all

electrical equipment and ignition switch. Never use any

fuse in excess of the designated rating.

(2) Be sure to employ a puller for removingnnstalling fuses.

Also, the removaYinstallation of fuses must

fuse is removed or installed in

twisted condition,

the terminal will be expanded unduly, resufting in poor

If any fuse is blown out repeatedly, the likelihood is that there

exists a short

the relevant system. Hence, perform checks

for possible systems, referring to Page and Section under

~wiring Diagram."

Chapters

Table of Contents