Daihatsu F300 Service Manual page 1233

ENGINE MECHANICAL$
12. Install the fuel hose No.1 to the fuel filter with a new gasket
interposed.
Tightening Torque: 34.3 - 44.1 N-m (3.5 - 4.5 kgf-m)
INSTALLATION OF TIMING BELT
(See page EM-31.)
1. Install the cylinder head cover temporarily.
2. Install the timing belt tensioner and tensioner spring. Tem-
porarily tighten them, while they are being pushed toward
the alternator side.
3. Align the mating marks of the crankshaft timing belt pulley
and camshaft timing belt pulley with the corresponding
mating marks.
4. Install the timing belt.
5. Loosen the tensioner attaching bolt so that tension may be
given to the belt.
Then, temporarily tighten the attaching bolt again.
6. Turn the crankshaft two turns in the normal direction.
7. Loosen the tensioner attaching bolt.
8. Turn the crankshaft until the "P' mark of the camshaft is
aligned with the indicator on the cylinder head cover.
9. Tighten the tensioner attaching bolt to the specified torque.
10.
Remove the cylinder head cover.
ADJUSTMENT AND INSTALLATION OF OTHER PART
1.
Adjustment
of
Vaive Clearances
NOTE:
• When tightening the adjusting nuts, apply engine oil to
the
lock nuts, adjusting
bolts and
rocker arms.
( 1) Align the stamped mark of the crankshaft timing belt
pulley with the indicator mark
of
the oil pump.
(2) Check to see if the valve rocker arms of the No. 1
cylinder are in a free state or they are pushed up by the
cam.
Adjust the valve clearances in accordance with the
table below.
The mark represents a valve which can be adjusted at
that time.
EM-92
Stamped
mark
Stamped
mark
"'''"'"'"'
•
•
•