Daihatsu F300 Service Manual page 916

•
•
•
•
WATER TEMPERATURE SENDER GAUGE
The water temperature sensor gauge ·,s located at the rear end
of the cylinder head.
Removal
1. Drain the cooling water
2. Remove the water temperature sender gauge.
Unit inspection
Measure the resistance between the terminal and the earth, as
indicated in the right figure. ·
Refer to previous pages .
Installation
1. Installation of water temperature Sender gauge.
(1) Wind sealing tape to the water temperature sender
gauge and install it to the cylinder.
Tightening Torque:
1.2- 2.0
kg-m
(8.7 - 14.5 ft-lb, 11.8 - 19.6 N·m)
NOTE:
• The new sensor is carted with sealer, therefore seal tape
is unnecessary if the gauge is replaced with new one.
(2) Connect the connector.
2. Fill the coolant
BE-21
~
BODY ELECTRICAL SYSTEM
WFE90-BE059